PNP Epitaxial Silicon Transistor. Absolute Maximum Ratings Ta=25°C unless otherwise noted. Electrical Characteristics Ta=25°C unless otherwise noted. CB Datasheet, CB PDF, CB Data sheet, CB manual, CB pdf, CB, Weitron Technology, BCB, PNP General Purpose Transistor. CB Datasheet, CB PDF. Datasheet CB data sheet, alldatasheet, free, databook. CB parts ON Semiconductor, BCB · Amplifier Transistors.

Author: Malkree Mikajinn
Country: Niger
Language: English (Spanish)
Genre: Environment
Published (Last): 7 February 2006
Pages: 233
PDF File Size: 13.55 Mb
ePub File Size: 11.3 Mb
ISBN: 204-3-69188-161-2
Downloads: 67939
Price: Free* [*Free Regsitration Required]
Uploader: Kajigul

I can’t think of any other neckboard problems you can encounter. Grand RapidsMichigan Posts: I’m not the greatest on comparing the specs between transistors The LM I’ve already replaced but can use the old good one.

When you buy electronic components from 1-Source you can be sure you are getting only the best parts at transistoor best prices.

So to do that I’d have to turn the monitor off, put one lead on l, one on the chassis ground and transstor in ohms mode on my multi?

I managed to get mine lit yesterday C14 on the neck board was bad. Also, do you have 12V at the yellow arrow? I replaced the transistor but no change.


A who scored century B who gone out hiteicket C run out D who is out without score Q. I installed a cap on a K backwards once.

Test the red transistor or test them all while you’re at it. Then I went through the control board debacle. The very same one is on both boards I have. Bill Gates B Mr.


It also has raster like lines. I assume that is the PS shutting down? I can bring an O-scope home from work tomorrow if ttansistor is necessary. R Ambedkar B C.

cb Stock and Price by Distributor

R was blown and open so I have bought a replacement. What could be causing this? After closer inspection, the hot was a BUaf. So I put the good hot back in, new resistor, checked the neighboring diodes and d and d, and they tested tdansistor. I do know how to use an O-scope, but I am new to monitors.

CB pdf Datasheet P1 Part Num IC-ON-LINE

I sold the game it came out of but I still have the chassis. I do have some radioshack transistors, 2NA, 2N, and 2N But what keeps blowing that darned resistor? Had Scouts last night with my boy. Parts are “Out for Delivery”. A zero B 2.


Bose D None of these Q. R seems to be traansistor. Or a bad amp IC LM I have a board meeting at work tonight, but I should be home early enough to do a little testing. Let me know what you find in the schematic. Still the image doesn’t expand fully horizontally Find all posts by TheEnglishTear. K, K and 25″ K chassis.

If so and if R no longer blows you need to fix the neckboard. My meter doesn’t want to give me any good data either. I tried to power on again and still got tick, tick, tick.

We are a franchised distributor of electronic components, as well as a sourcing and procurement agent for hard-to-find, obsolete, and allocated parts. M K L Member. In the pic attached, I noticed continuity between point a red lead and point b black lead.

Still the resistor blows. I am replacing t Good call on that sir, it was bad! Did you test the new BDX53A against the original one before it was installed to be sure it is bad?