Intecont Tersus – Free download as PDF File .pdf), Text File .txt) or read for weighing tasks better than % Manual and/or automatic zero setting Full. The INTECONT Tersus weighing elec- tronics is specially tion module, INTECONT Tersus optimally fits into any Manual and/or automatic zero setting. processes, the INTECONT Tersus meas- uring, control, and supervisory module, INTECONT Tersus optimally fits into any Manual and automatic zero setting.

Author: Nesida Tell
Country: Liechtenstein
Language: English (Spanish)
Genre: Travel
Published (Last): 27 March 2014
Pages: 46
PDF File Size: 7.13 Mb
ePub File Size: 7.50 Mb
ISBN: 443-6-11251-382-2
Downloads: 94346
Price: Free* [*Free Regsitration Required]
Uploader: Mekora

Tachometer Input A P It makes sense to go through all of the parameters and consider the value entered. If it is not possible to bring about a reasonable operational state in spite of all efforts, the test plug chapter might help. Subject to change without prior notice. The effective load is always the applied weight QP. The feed rate is regulated on a weighfeeder according to a setpoint. In sum, a well-rounded operating majual concept for discerning operators who are looking for more than just operating and monitoring functions.

It describes the functionali-ty of the VWF xxx software.

It can be printed out with the Batch Record function or automatically after every finished batch P You can give the technical name at the installation location in the header.

Furthermore they may also cause considerable disruption to weigh operations. The keyboard setpoints are stored.


Key in the sensor width in P They can inspected without any hazard with the Read Parameters function. Single-Idler Platform The load on the weighing platform is conducted via a weighing idler into the load cell. Relevant parameters Behavior if alarm Triggered: WZ connection diagram and tachometer The selected space of the first level has an orange background. An external performance level with anchor tension or speed regulation is needed for the drive in all cases.

Compensation adapts itself whenever material is conveyed.

That is why we consider a comprehensive service concept nanual par for the course, from strict quality control, installation and commissioning through to seamless support across the entire product life cycle.

The measuring system must be shut down before work is performed on mechanical equipment or peri-pheral devices control systems in particular.


Belt impact measurement is constant to take changes in regular operation into account. The effective calibration weight QPRF is the weigh-ing platform load in kg simulated by the calibration weight. This manual is available intfcont different forms: It can be integrated in the control panel or is available with a glass fibre reinforced plastic wall-mounted housing for on-site installation.

The value for the plant can be adapted through P The Nominal Belt Load calculated from the rated values functions internally.

Parameters Function Range P This changes the speed of the conveyor belt until the actual value is equal to the terxus. The feed rate will only be calculated with the feeder switched on and during the stopping time P Belt Skew WM04 Event: The value must approximately correspond to the information in the data sheet.


Suitable calibration weights are available as accessories.

Manual Intecont Tersus

If Feedrate Setpoint P Bulk solids can be transported and cover the following equipment. This is why it is normally only possible to guarantee a high level of maunal over entire belt cir-cuits i. Hidden parameters can only be shown with the EasyServe service software and they can also be cleared there for the dis-play on the unit wherever necessary.

This space has a yellow background.


Gravimetric Controlled operation as described above Volumetric Uncontrolled operation, i. The batch has to be ended or cancelled. Amnual turn-off point and the utilization of “dribble feed” can be automatically adapted. Poten-tial hazards may then arise from e. It must change if the weighing platform is placed under load e.

Read the mean of the belt load q1 a on the equipment and key it into the Linearization I1 parameters.